trchan(M)
trchan --
translate character sets
Syntax
trchan [ -ciko ] mapfile
Description
trchan performs mapping as a filter, using the
same format of mapfile as
mapchan(M)
(described in
mapchan(F)).
This allows a file consisting of one internal character set
to be ``translated'' to another internal character set.
trchan reads standard input, maps it, and writes
to standard output. A mapfile must be given on
the command line. Errors cause trchan to stop
processing unless -c is specified.
The following options can be used with trchan:
-c-
causes errors to be echoed on stderr, and processing is continued.
-i-
specifies that the ``input'' section of the mapfile
is used when translating data.
-k-
specifies that the ``dead'' and ``compose'' sections of the
mapfile are used when translating data.
-o-
specifies that the ``output'' section of the mapfile
is used when translating data.
The -i, -k and -o
options can be specified in any combination;
if none are specified, trchan uses the entire mapfile,
as if all three were specified together.
Limitations
trchan
currently ignores the control sections of the mapfile.
Files
/usr/lib/mapchan/
See also
ascii(M),
iconv(C),
mapchan(F),
mapchan(M)
Standards conformance
trchan is not part of any currently supported standard;
it is an extension of AT&T System V provided by
The Santa Cruz Operation, Inc.
© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003