System does not recognize all hard disks during installation
During initial system load, you can configure a maximum of
four disks under the Interactive fdisk/divvy disk setup option.
Any additional disks on your system are recognized by SCO OpenServer,
but they are not displayed for configuration during initial system load.
You can configure these disks after initial system load using
the Hardware/Kernel Manager
or the mkdev hd command
(described in the
System reboots from Boot Disk or screen blanks after Boot: prompt
Upgrade option not displaying on systems with multiple host adapters
© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003