Smartmodem 2400, V-series 9600 or compatible
The Hayes 2400 and V-series 9600 Smartmodem or AT-compatible modems
are supported and are configured automatically when you use the
dialer entries or dialer programs supplied with the SCO OpenServer
distribution. If you are using an unsupported dialer (one brought
from elsewhere or written yourself),
and you plan to use it for a dial-in line, be sure that you
use the following settings:
fetches factory configuration
is tone dialing
is low speaker volume
sets dtr ``2'': goes on hook when dtr drops
sets dcd ``1'': dcd tracks remote carrier
answers phone after one ring (AA light should come on)
disables modem escape sequence
does not echo (modem no longer echoes what is sent to it)
is quiet mode (modem does not respond with ``OK''
after this command or any that follow)
saves settings in non-volatile memory.
If you do not want to save the settings, you do not
have to enter this command.
AT-compatible switch settings
© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003