gateway routing daemon
/etc/gated [ -c ] [ -C ] [ -n ]
[ -N ]
[ -ttrace_options ]
[ -fconfig_file ]
[ trace_file ]
gated is a routing daemon that handles multiple
routing protocols and replaces
and any routing daemons that speak the
EGP, OSPF, or BGP routing protocols.
gated currently handles the RIP,
BGP, EGP, and OSPF routing
protocols. The gated process can be configured
to perform all routing protocols or any combination of the
The SCO TCP/IP start/stop script,
starts and stops the gated daemon when a
variable pair is set to
/etc/gated in the
configuration file (/etc/default/tcp).
You can use the
command to control the operation of gated.
The command-line options are:
If on the command line a trace file is specified, or no trace
options are specified, gated detaches from the terminal
and runs in the background. If trace options are
specified without specifying a trace file, gated
assumes that tracing is desired to stderr and
remains in the foreground.
Specifies that the configuration file will be parsed for
syntax errors and then gated will exit; if there
were no errors, gated will leave a dump file in
/usr/tmp/gated_dump. gated does not
need to be run as root to use the -c
option, but it may not be possible to read the kernel
routing table and interface configuration if not run as
root. The -c option implies
-tgeneral,kernel,nostamp. All traceoption and
tracefile clauses in the configuration file will be
Specifies that the configuration file will just be parsed for syntax
errors. gated will exit with a status of 1 if there were any
errors and 0
if there were not. gated does not need to be run as
root to use the -C option,
but it may not be possible to read the kernel routing
table and interface configuration if not run as root.
The -C option implies -tnostamp.
Specifies that gated will not modify the kernel's
routing table. This is used for testing gated
configurations with actual routing data.
Specifies that gated will not daemonize.
Normally, if tracing to stderr is
not specified, gated will daemonize if
the parent process ID is not 1. This
allows the use of an /etc/inittab-like
method of invoking gated that does not
have a PID of 1.
Specifies a comma separated list of
trace options to be enabled on startup.
If no options are specified, ``general'' is
assumed. No space is allowed
between this option and its arguments.
This option must be used to trace events
that take place before the configuration file
is parsed, such as determining the
interface configuration and reading
routes from the kernel. The trace options
are explained in greater detail in
Use an alternate configuration file.
gated catches the following signals and does
Reread configuration. A SIGHUP causes
gated to reread the configuration file.
gated first performs a clean-up of all allocated
policy structures. All BGP and EGP peers
are flagged for deletion and the configuration file is
If the reparse is successful, any BGP and
EGP peers that are no longer in the configuration
are shut down, and new peers are started. gated
attempts to determine if changes to existing peers require
a shutdown and restart.
It should also be possible to enable/disable any protocol
without restarting gated.
Reconfiguration is currently disabled when OSPF
is enabled; this will hopefully be fixed in a
Snap-shot of current state. The current state of all
gated tasks, timers, protocols and tables are
written to /usr/tmp/gated_dump.
This is done by forking a subprocess to dump the table
information so as not to impact gated's routing
functions. On systems where memory management does not
support copy-on-write, this will cause the gated
address space to be duplicated; this may cause a noticeable
impact on the system.
Graceful shutdown. On receipt of a SIGTERM,
gated attempts a graceful shutdown. All tasks
and protocols are asked to shut down. Most will terminate
immediately, the exception being EGP peers which
wait for confirmation. It may be necessary to repeat the
SIGTERM once or twice if this process takes too
All routes except interface routes, static routes marked with
`retain', and routes marked with RTF_STATIC (on systems that
support it, these routes are added with the route command) are
removed from the kernel's routing table on receipt of a SIGTERM.
The rationale behind this is that static routes provide the minimal
routing to each router when
is not running. To terminate
with all the routes intact, use SIGKILL or
SIGQUIT (which causes a core dump).
Toggle tracing. On receipt of a SIGUSR1,
gated will close the trace file. A subsequent
SIGUSR1 will cause it to be reopened. This will
allow the file to be moved regularly.
It is not possible to use SIGUSR1 if a trace file
has not been specified or tracing is being performed to
Check for interface changes.
On receipt of a SIGUSR2, gated will rescan the kernel
interface list looking for changes.
startup configuration file
current gated configuration file
gated's state dump file
where gated drops its core file
© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003