Olivetti ESC-1, ESC-2, and EFP host adapter driver
This driver is no longer supported by SCO, however,
it is still provided with SCO OpenServer for your convenience.
Contact your hardware vendor for support.
efp is the device driver for
Olivetti ESC-1, ESC-2,
and EFP host adapter cards.
Refer to the
Compatible Hardware Web Pages.
to determine the support status of your host adapter, or
contact your system supplier.
Configuring the efp driver
You can configure the efp driver using entries in
/etc/conf/cf.d/mdevice and /etc/conf/sdevice.d/efp.
Changes to these files
take effect once you relink the kernel using
and reboot the system.
Configure efp driver-specific characteristics
by editing the /etc/conf/pack.d/efp/space.c file,
which controls parameters such as
displaying configuration at init time and
displaying driver-specific warning messages.
Boot time configuration of SCSI
parameters to override
the default hardware configuration information.
Of special interest are the adapter= parameter
that specifies information for
the host adapter card
that plugs into or is part of the motherboard,
and the periph= parameter
that specifies information about the host adapter
being used by one of the generic peripheral interfaces
(Sdsk, Srom, or Stp).
The efp driver
supports all standard SCSI ioctls
that are defined in the <sys/scsicmd.h> header file
and documented on the
for general information about kernel error messages,
including a list of generic device driver errors.
SCSI interface header files
``Adding SCSI host adapters and peripherals'' in the SCO OpenServer Handbook
SCO OpenServer System Administration Guide
© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003